Trophy- for eventual tournament :)

by **LotharBot** » Fri Sep 06, 2013 7:21 pm

I'll be impressed if Iowa wins the DCL trophy.

by **LoNi_** » Fri Sep 06, 2013 7:26 pm

by **Drakona** » Fri Sep 06, 2013 7:54 pm

Mark392 is from Iowa. Could happen.

by **RiTides** » Sat Sep 07, 2013 1:36 pm

The pyros have multiplied :). Enough for 2 tournies now!

I printed these all at once as it will be easier to work on them in batches, and because my grey resin arrived today so tomorrow I am switching the printer over to grey... no more clear, for now!

I also printed out some cylinders to fix the gun shafts with. I'll be using the tips that are printed out in the picture below, but replacing the shafts and gluing them in place, as some of the shafts came out a little wobbly or not fully cured (I knew that was a possibility and oriented to make the body come out best, since I can replace the shafts).

So, remaining to-do:

1. Receive light base
2. Model base rings for large pyro and plaques for small pyros
3. Lasercut base rings for large pyro and plaques for small pyros
4. Figure out how to stencil information on base rings and plaques
5. Remove supports and then glue gun shafts onto large and small pyros

by **Jediluke** » Sat Sep 07, 2013 8:37 pm

sweetness

by **LoNi_** » Thu Sep 12, 2013 2:42 pm

by **RiTides** » Fri Sep 13, 2013 9:48 am

Yeah, that's awesome!

Although atm the trophies are only going to be for a special event tourney, not for normal ladder placement... I can only make so many of these things ;)

by **DKH** » Fri Sep 13, 2013 4:32 pm

Marks deserves that! Look how many games he's played... Well done. Now lets see how many times you can defend that rank!

Ahhhhh Yeaahhhh